Curing Lights

PowerLite™ LED Curing Light is a curing unit that utilizes an advanced light emitting diode technology for the optimum polymerization of camphorquinone based bonding materials in the 450 to 490nm visible light range.

PowerLite™ LED Curing Light is capable of curing most bonding materials in 10 seconds with its powerful 1200mW/cm2 intensity allowing for a faster bonding procedure.

With its ergonomic, cordless and compact design PowerLite™ gives you additional freedom not only intraorally but also from chair to chair.

It utilizes a new self-monitoring heat-sink technology which controls heat emission. The fan-free and vent-free construction creates a fully sealed, aseptic environment while protecting the electrical components from liquids and contaminants.
Operated with 2000mAh Li-ion battery for ideal performance the PowerLite™ LED Curing Light provides 400 ten second cures with one fully charged battery.

It’s all in the science, it’s the intelligent approach to curing lights and to modern dentistry. It is the ideal combination of Power, Design and Technology.
Power

• Powerful LED module providing high intensity 1,200mWcm2 intensity. The higher intensity allows more light penetration to cure the composite under the bracket achieving faster polymerization with an increased depth of cure.
• Emitted light wavelength 470 nm range of light spectrum which corresponds to the maximum absorbance of camphorquinone assuring maximum curing for most adhesives.
• RAMP, FAST, CONSTANT & PULSE curing modes in offer additional versatility while preventing stress in composite material and increasing depth of polymerization.
• Depth of cure comparable if not better than high output halogen curing lights.
• High speed, 10-second cure for most composites.
• Operated with 2000mAh Li-ion battery for ideal performance with no memory effect.
• Power Input – 100 – 240 V / 50 – 60 Hz intelligent power supply.

Design

• Cordless design and compact body providing high maneuverability not only intraorally, but also from chair to chair.
• New dimension in ergonomic design – comfortable for every hand with functional angles
• Long light guide for complete freedom of movement especially in the posterior sections
• Mode & timer selection with soft, easy-to-reach buttons, and user friendly ambidextrous control
• Built-in battery charger with light intensity meter for continuous performance
• Stable charging station for a safe hand piece position.
• Weight of the hand piece with rechargeable battery – 260 gr.
• Pre-selected timer – 10, 20, 30 sec
• Audible tones every 10 sec for increased status communication

Technology

• Single high-tech LED module using the latest achievements in LED technology
• No heat, no fan, no noise. It uses heat-sink technology to minimize the amount of heat emission.
• Smart self diagnostics and controls to detect internal temperature during curing cycle for automatic shut off to prevent overheating.
• Fan-free and vent-free construction creates a sealed, aseptic environment while protecting the electrical components from liquids and contaminants.
• Sleep mode for efficient battery use will start if the unit has not been used after 30sec. The unit will start again with a push of the start button in the last mode used.
• Up to 400 ten second curing cycles with one full battery
• Digital display of curing mode and timer providing information about selected curing mode, timer and remaining time.
• Long life LED light source last thousands of hours however a halogen light bulb must be replaced in as few as 50 hours.
• Up to 3 years of limited warranty.